| Container
Filter - Front Loader Model - Specifications
Click
Here For A Technical Drawing & Model Information
Note: The
above link is an Adobe Acrobat file. If you do not have
the Adobe Acrobat Reader, then you can download it by
clicking the logo.
|
|
- Container walls are constructed of 10-gauge
carbon steel plate, with floor constructed of 7-gauge carbon
steel plate.
- Walls and floor are reinforced by structural
angle and formed channel framing.
- Has internal support panel(s) to which
filter media is attached.
- Two - 2" female threaded drainage ports
are provided on the container body below the bottom position
of the interior support panel.
- Designed to be unloaded by a standard
"front loader" type waste truck.
- Exterior and interior surfaces of container
and support basket will be sand blasted, 2-part epoxy primed,
and upper coated with polyurethane
Basic Style
Container filter support
panels are load support for the filter media and are constructed
of 1/4" carbon steel perforated plate (1/4" hole on 3/8" center).
A wide range of filter media is available for this style.
Filter media with back-up material is contour fitted onto
a support panel and secured in place with retainer bars, stainless
steel socket set screws with fender washers, and acorn nuts.
Filter support and filter media cover the floor of container.
A pump can be used to pull a vacuum on cavity below filter
support. Filter supports are removable for cleaning of container.
Standard Style
Container filter panels
are load support for the filter media and are constructed
of 1/4" carbon steel perforated plate (1/4" hole on 3/8" center).
A wide range of filter media is available for this style.
Filter media with back-up material is contour fitted onto
a support panel and secured in place with retainer bars, stainless
steel socket set screws with fender washers, and acorn nuts.
Filter support and filter media cover the floor and part of
back wall of container. Back wall filter drains into bottom
cavity. A pump can be used to pull vacuum on cavity below
filter support. Filter supports are removable for cleaning
of container.
Gravity/Vacuum
Style
Container filter support
panels are load support for the filter media and are constructed
of 1/4" carbon steel perforated plate (1/4" hole on 3/8" center).
A wide range of filter media is available for this style.
Filter media with back-up material is contour fitted onto
a support panel and secured in place with retainer bars, stainless
steel socket set screws with fender washers, and acorn nuts.
Filter support and filter media cover the floor and part of
side and back walls of container. Side and back wall filters
drain into a cavity separated from the cavity to which the
bottom filters drain. This allows sludge to dewater by gravity
through side and back wall filters while a pump is used to
pull a vacuum on the bottom filter. Additional set of 2" FNPT
threaded drainage ports is provided to drain the side and
back wall filters. Filter supports are removable for cleaning
of container.
|
Houston 