Click Here For A Technical Drawing & Model Information

Note: The above link is an Adobe Acrobat file. If you do not have the Adobe Acrobat Reader, then you can download it by clicking the logo.

• Container is constructed of 1/4" A-36 carbon steel plate with structural steel outside bracing, and reinforced pick-up hooks.
• Unit is seal welded on all interior surfaces and seal welded on top of all exterior surfaces.
• Exterior and interior surfaces are sandblasted, 2-part epoxy primed and upper coated with polyurethane.
• Each container wall is made of one piece of plate and the floor is made of one piece of plate.
• The sides are reinforced horizontally with 5" channel (6.7 lb./ft.) centered at lift hooks. 5" reinforcing channels (6.1 lb./ft.) project to top of box from lift hooks.
• Lift hooks are made of 2" solid rod welded to box sides projecting through and seal welded to outside of 5" reinforcing channel.
• Dump hook is made from 1-1/8" diameter solid rod with brackets welded to the container. The inside of the container is reinforced with 1/4" plate at the dump hook.
• Two skid runners are welded to the bottom of the container extending the length from back to front causing the container to slope towards the front (where drain ports are located).
• Container has two 2" drainage ports on the same end as the dump hook.
• Filter support is constructed of 1/4 perforated carbon steel plate with 1/4" holes on 3/8" center.
• Container top is reinforced with 3" x 3" x 1/4" angle iron.
• Welds between walls and between wall and floor are continuous.

---

Basic Style

Container filter support panels are load support for the filter media and are constructed of 1/4" carbon steel perforated plate (1/4" hole on 3/8" center A wide range of filter media is available for this style. Filter media with back-up material is contour fitted onto a support panel and secured in place with retainer bars, stainless steel socket set screws with fender washers, and acorn nuts. Filter support and filter media cover the floor of container. Filter support are removable for cleaning of container. A pump can be used to pull a vacuum on cavity below filter support.

Container filter panels are load support for the filter media and are constructed of 1/4" carbon steel perforated plate (1/4" hole on 3/8" center). A wide range of filter media is available for this style. Filter media with back-up material is contour fitted onto a support panel and secured in place with retainer bars, stainless steel socket set screws with fender washers, and acorn nuts. Filter support and filter media cover the floor and part of back wall of container. Back wall filter drains into bottom cavity. A pump can be used to pull vacuum on cavity below filter support. Filter supports are removable for cleaning of container.

Container filter support panels are load support for the filter media and are constructed of 1/4" carbon steel perforated plate (1/4" hole on 3/8" center). A wide range of filter media is available for this style. Filter media with back-up material is contour fitted onto a support panel and secured in place with retainer bars, stainless steel socket set screws with fender washers, and acorn nuts. Filter support and filter media cover the floor and part of side and back walls of container. Side and back wall filters drain into a cavity separated from the cavity to which the bottom filters drain. This allows sludge to dewater by gravity through side and back wall filters while a pump is used to pull a vacuum on the bottom filter. Additional set of 2" FNPT threaded drainage ports is provided to drain the side and back wall filters. Filter supports are removable for cleaning of container.