Flo Trend Systems - Container Filters, Dewatering Equipment, Filtration, Oil/Water Separators

Note: The above link is an Adobe Acrobat file. If you do not have the Adobe Acrobat Reader, then you can download it by clicking the logo.

Container is constructed of A-36 carbon steel plate with 1/4" floor and 3/16" walls.
Exterior and interior surfaces are sandblasted, 2-part epoxy primed and upper coated with polyurethane.
Container has rounded bottom with an EPDM gasketed water tight door.
Two 3" drainage ports are located on each side for gravity drainage or pump suction (2 additional 3" drainage ports are located in the front of the box for Gravity/Vacuum style).
Door of container is made of 3/16" A-36 plate with door frame perimeter made of 4" x 3" x 3/16" tubing and door frame interior made of 3/16" plate channels. All parts of door are continuously welded.
Container has hinges that allow for an offset for door movement when sealing. Container has a double latch with dual locking safety mechanism.
Top rail is made of 4" x 3" x 36" tubing. Rear posts are made of 16" x 3/16" plate channels.
Side posts are made of 16" x 3/16" 10 gauge channels. Front posts are made of 3/16" plate channels - 8" wide.
Wheels are 10" diameter x 12" wide - diagonally braced. Floor is framed over 3" channel cross members and end members and welded as a one-piece floor and beam system.
Container is seal welded on all interior surfaces and seal welded on top of all exterior surfaces.

Basic Style

Container filter support panels are load support for the filter media and are constructed of 1/4" carbon steel perforated plate (1/4" hole on 3/8" center). A wide range of filter media is available for this style. Filter media with back-up material is contour fitted onto support panels and secured in place with retainer bars, stainless steel socket set screws with fender washers, and acorn nuts. Filter support and filter media cover the floor of container. Filter support is removable for cleaning of container. A pump can be used to pull a vacuum on cavity below filter support.

Container filter support panels are load support for the filter media and are constructed of 1/4" carbon steel perforated plate (1/4" hole on 3/8" center). A wide range of filter media is available for this style. Filter media with back-up material is contour fitted onto support panels and secured in place with retainer bars, stainless steel socket set screws with fender washers, and acorn nuts. Filter support and filter media cover the floor and part of side walls of container. Side wall filters drain into bottom cavity. Filter supports are removable for cleaning of container.

Container filter support panels are load support for the filter media and are constructed of 1/4" carbon steel perforated plate (1/4" hole on 3/8" center). A wide range of filter media is available for this style. Filter media with back-up material is contour fitted onto support panels and secured in place with retainer bars, stainless steel socket set screws with fender washers, and acorn nuts. Filter support and filter media cover the floor, part of side walls and front wall of container. Wall filters drain into a cavity separated from the cavity to which the bottom filters drain. This allows sludge to dewater by gravity through side filters while a pump can be used to pull a vacuum on the bottom filter. Filter supports are removable for cleaning of container.