| Container
Filter - Tipping Stand Mounted Sludge Mate® - Specifications
Click
Here For A Technical Drawing & Model Information
Note:
The above link is an Adobe Acrobat file. If you do not have the Adobe Acrobat
Reader, then you can download it by clicking the logo.
|
|
- Container is constructed of A-36 carbon steel plate with
7-gauge floor and 10-gauge walls.
- Two 2" or 3" drainage ports are
located on each side for gravity drainage or pump suction
(2 additional 2" or 3" drainage ports are located in
the front of the box for Gravity/Vacuum style).
- Door of container is made of 3/16" A-36 plate with door
frame perimeter made of 4" x 3" x 3/16" tubing and door frame interior made
of 3/16" plate channels. All parts of door are continuously welded. Door sealing
face will be totally watertight and have an EPDM gasket on the surface area.
- Hinges are constructed of 1/2" wall steel tubing and 1"
diameter hot rolled bar pins with welded retainer washers.
- Rails are constructed of 6" x 2" x 3/6" structural tubing
with 36-1/2" inside spacing.
- Floor is framed over 3" channel cross members and end
members and welded as a one-piece floor and beam system.
- Container is seal welded on all interior surfaces and
seal welded on top of all exterior surfaces.
- Exterior and interior surfaces are sandblasted, 2-part
epoxy primed and upper coated with polyurethane.
- Tipping stand specifications as follows:
- Single cylinder scissors type hoist. (5 - 15 cu. yd.)
- Dual cylinder scissors type hoist. (20 - 25 cu. yd.)
- Vertical single cylinder telescopic type hoist. (30
- 40 cu. yd.)
- AC motor operated. (12 - 15 cu. yd. - 1/60/120V, 20
- 40 cu. yd. - 3/60/220 or 460V required)
- Hydraulic pump with hydraulic oil
reservoir.
- Remote control station mounted on front of the unit
at ladder side.
- Stand extension legs to necessary heights are available
on request.
|
Houston